Zhangqiu Yunlong Machinery Co

Water slag dryer
Water slag dryer is a dryer that handles a large amount of materials
. It has large production capacity, wide application range, small flow resistance, easy operation, and is often used for drying. < r_b >Sand
< r_b >River sand
< r_b >Slag
< r_b >Cinder
< r_b >Quartz sand
etc.
The water slag drying equipment mainly includes:
Cylinder front roller ring, rear roller ring, gear block roller, drag roller, pinion gear, discharge part, lifting plate reducer
< r_b >Motor
It is composed of hot air duct, feed chute and furnace body, etc.
Working principle of water slag drying equipment

Slag dryer
Water slag is conveyed by belt conveyor
or The material is sent to the hopper by the bucket elevator, and then enters the feeding end through the feeding pipe through the feeding machine of the hopper. The inclination of the feeding pipe should be greater than the natural inclination of materials to facilitate materials to flow into the dryer smoothly. The dryer cylinder is a rotating cylinder, which is slightly inclined with the horizontal line. Materials are fed in through the higher end, and heat carrier enters through the lower end, and contacts with materials in counter-flow. Sometimes heat carrier and materials flow into the cylinder together. As the cylinder rotates, the materials move to the lower end due to gravity. When the wet materials move forward in the barrel, they receive the heat from the heat carrier directly or indirectly, and the wet materials dry. Then, the wet materials are sent out through the discharge end through a belt conveyor or screw conveyor. The inner wall of the barrel is equipped with a lifting plate, which can lift the materials and scatter them, increases the contact surface of the materials and the airflow, in order to improve the drying rate and forward the materials advancement. Heat carriers are generally divided into hot air, flue gas, etc. After the heat carrier passes through the dryer, a cyclone dust collector is generally required to collect the materials in the gas. If you need to further reduce the dust content of the exhaust gas, it should also be discharged after passing through a bag dust collector or wet dust collector